丁基胶涂布机常见问题的解决方法：
The common problems of the butyl rubber coating machine are solved:
1.铝框上出现一边或两边都不沾胶的现象时
The phenomenon of no glue on either side or both sides of the 1. aluminum frame
乐竞网页版网站官网登入应检查胶缸、胶头的温度是否正常，压力是否在乐竞网页版网站官网登入设定的范围之内，检查两胶头的距离是否过大（此距离设定至铝条刚刚能从两个打胶头之间过去为好）。
We should check whether the temperature of the rubber cylinder and the rubber head is normal, whether the pressure is within our range, and check whether the distance between the two rubber heads is too large (the distance is set to the aluminum strip can just pass from the two rubber heads to the best).
如果上述情况都没有问题，可断定两个打胶头（或一个），由于丁基胶中有杂质而堵住了胶头出胶的眼，这就需要卸下打胶头，用煤油浸泡，然后将胶头内的胶全部清理干净后再装上即可。
If the above conditions are all right, two glue heads (or one) can be determined. Because of the impurities in the butyl rubber, the gel head is blocked out, so we need to remove the rubber head and soak it in kerosene, then clean the glue in the adhesive head and then install it.
2.该设备全部采用液压系统，油缸及液压系统全部采用高压油管连接，每个连接处都由组合垫密封，若发现漏油，及时更换组合垫。

2., the hydraulic system is used in all the devices. The oil cylinder and hydraulic system are all connected by high pressure oil pipe. Each connection is sealed by combination gaskets. If we find oil leakage, replace the combination cushion in time.
3.该设备的胶头加热和胶缸加热，由加热棒两个和加热盘一个提供，由温控表来设定和调整温度的高低，若发现温度升不高或升高后往下降，请检查加热棒或加热盘是否损坏，并检查温控表是否正常。
3. the equipment glue and glue cylinder head heating heating, the heating rod two and a heating plate, a temperature control table to set and adjust the temperature, if the temperature rise is not high or increased after going down, please check the heating rod or the heating disc is damaged, and check whether the normal temperature table.
客户的满意就是对乐竞网页版网站官网登入的肯定，欢迎您前来选购我公司的产品，乐竞网页版网站官网登入一直以为您提供产品为己任并一直坚持这样做。欢迎您的光临。
Customer satisfaction is our affirmation. You are welcome to purchase our company's products. We have always thought that you are responsible for products and have always insisted on doing so. Welcome to your visit.